Why there is no diffrences in rendering time between OFF and other values in MULTITHREADING option? Apophysis doesn't utilize multithreading at all. Task manager always shows only 12% of CPU utilization.
My config:
CORE I7 920, 6 GB RAM, Windows 7 x64
Multithreading
4 posts
• Page 1 of 1
Re: Multithreading
by PAEz » Wed Dec 28, 2011 4:29 pm
That seems a little odd, it does for me.
I only have a intel duo (2 cores) and when its off it uses 50% of my cpu and when its set to two it uses 100%.
So I wonder why not for you?
Well actually thats in Apophysis 7x, I just tried it in Apophysis 2.09 and it only got between 70-89% but its still using 2 cores.
If your not using 7x then give that a try.
And preview in both versions seems to only use one core.
I only have a intel duo (2 cores) and when its off it uses 50% of my cpu and when its set to two it uses 100%.
So I wonder why not for you?
Well actually thats in Apophysis 7x, I just tried it in Apophysis 2.09 and it only got between 70-89% but its still using 2 cores.
If your not using 7x then give that a try.
And preview in both versions seems to only use one core.
- PAEz
- Posts: 5
- Joined: Sun Dec 11, 2011 12:34 am
Re: Multithreading
by Pinto » Thu Dec 29, 2011 1:25 am
Ok, I checked rendering and CPU utilization was 100% 
I think that preview should utilize multithreading too, because we spend more time on previewing than rendering
I think that preview should utilize multithreading too, because we spend more time on previewing than rendering - Pinto
- Posts: 3
- Joined: Fri Dec 23, 2011 9:07 am
Re: Multithreading
by Pinto » Sun Jul 08, 2012 10:46 am
Apophysis still doesn't utilize multithreading in preview rendering. It is very frustrating.
- Pinto
- Posts: 3
- Joined: Fri Dec 23, 2011 9:07 am
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: neacroend, PynccyncRer and 0 guests